Filter
Top Products
Programmable Functions
15
Preparation
H
Save DIRECT#
Set flash time
Set line mode
Talk switching
Set dial mode
TAD program
You can program the following function items using the handset near
the base unit. The display shows the programming instructions. See the
corresponding pages for function details.
Make sure the unit is in the standby mode initially.
During programming:
*To select a desired function item, press Ö or Ñ repeatedly until the
arrow points to the item. Then press á to go to the next step.
•You can exit the programming mode any time by pressing (OFF).
•If you do not press any buttons for 60 seconds, the unit will return to the standby
mode.
•If the handset has lost communication with the base unit, an alarm tone sounds
and “No link to base. Place on cradle and try again.” is
displayed.
•If 3 beeps sound and the display shows “Save error”, move closer to the base
unit and try again.
Press (FUNCTION/CH).
<Function menu>*
To store an item in the directory (p. 42).
To select the ringer volume (p. 17).
To dial the stored pager number (p. 61).
Press á.
To store a phone number in the DIRECT button
(p. 40).
To select the flash time (p. 53).
To select the line mode (p. 14).
To set the auto talk feature (p. 16).
To select the dial mode (p. 13).
To program answering system functions (p. 20).
H
Save directory
Ringer volume
Program
Calling pager
<Function menu>*