Panasonic KX-TG2388 Cordless Telephone User Manual


 
Programmable Settings
40 For assistance, please visit http://www.panasonic.com/consumersupport
another person answers the call using
another phone connected on the
same line.
1 Press {MENU}.
2 Scroll to “Ringer setting” by
pressing {V} or {^}, then press
{Select}.
3 Scroll to “Ringer tone”by pressing
{V} or {^}, then press {Select}.
4 Select the desired ringer tone by
pressing {V} or {^}.
LThe handset will ring and the ringer
tone will change. If the handset ringer
volume has been turned off, the
handset will not ring.
LYou can also select the ringer tone by
pressing {1} to {7}.
5 Press {Save}, then press {OFF}.
Base unit ringer tone
Using the base unit
Make sure the base unit is not being
used.
Press VOLUME {<} or {>}, then select
the desired ringer tone by pressing {1} to
{7}.
{1} to {3} : Bell ringer patterns
{4} to {7} : Melody patterns
LAfter pressing VOLUME {<} or {>}, the
base unit will ring using the current
ringer tone.
LThe base unit will ring and the ringer
tone will change.
LTo stop ringing, press {STOP}.
Using the handset
1 Press {MENU}.
2 Scroll to “Initial setting” by
pressing {V} or {^}, then press
{Select}.
3 Scroll to “Set base unit” by pressing
{V} or {^}, then press {Select}.
4 Press{Select} at “Ringer tone”.
5 Select the desired ringer tone by
pressing {V} or {^}.
LThe base unit will ring and the ringer
tone will change. If the base unit
ringer volume has been turned off,
the base unit will not ring (page 39).
LYou can also select the ringer tone by
pressing {1} to {7}.
6 Press {Save}, then press {OFF}.
Handset incoming call tone
During an intercom call (page 32), you can
be informed of incoming calls by two
tones. If this feature is turned on, incoming
call tones will be heard for as long as the
line is ringing. If this feature is set to “2”,
incoming call tones will be heard only 2
times.
If this feature is turned off, no tones will be
heard.
1 Press {MENU}.
2 Scroll to “Ringer setting” by
pressing {V} or {^}, then press
{Select}.
3 Scroll to “Incoming call.” by
pressing {V} or {^}, then press
{Select}.
4 Select “On”, “Off” or “2” by pressing {V}
or {^}.
5 Press {Save}, then press {OFF}.
Base unit incoming call tone
1 Press {MENU}.
2 Scroll to “Initial setting” by
pressing {V} or {^}, then press
{Select}.
TG2388.book 40 ページ 2005年7月14日 木曜日 午後4時58分