Panasonic kx-ncp500 Wireless Office Headset User Manual


 
A
Is the card installed in the appropriate slot?
Is the card installed in the correct slot, but not functioning correctly?
Check the condition of the card.
Is the card itself in INS status?
Set it to INS status.
Is a trunk line connected to the appropriate port?
Is the port in FAULT status, even though a trunk is connected?
Run diagnosis on the relevant slot.
Q How do I prevent newly installed cards automatically being changed to "INS"?
A
Change
New Card Installation—Card Status for any Card in 3.48 [1-3]
Option from "In Service (INS)" to "Out of Service (OUS)".
Portable Stations
Q I cannot register Portable Stations using the method described in Portable Station
[1-2].
A
Is the status of the DHLC or DLC card set to "INS"?
Is a CS connected to the DHLC or DLC card? If not, connect one.
Do the PINs (Personal Identification Numbers) of the PBX and the Portable Station
match? Confirm that they are the same.
Is the Portable Station within transmission range of the CS?
Has the Portable Station previously been registered at another location?
It is not possible to register a Portable Station at 2 locations, so use the Forced
De-registration option to delete the previous registration.
Q I cannot delete the extension number of a Portable Station.
A
First, de-register the Portable Station itself, and then delete the extension number.
Q I cannot de-register a Portable Station.
A
Is the Portable Station turned on? If not, turn it on.
Is the Portable Station within transmission range of the CS? If not, move it closer to
the CS and try the de-registration operation again.
Q The Portable Station I want to de-register is broken, and will not turn on, or is not
available, or
the registration information was deleted first from the Portable Station,
so it cannot be de-registered.
A
The Portable Station can be forcibly de-registered by following the procedure shown
in
Forced De-registration of 3.47 [1-2] Portable Station.
Q I changed the extension number of a Portable Station, but the display of the Portable
Station still shows the old extension number.
A
Turn the Portable Station off and back on again, to force it to re-register its location.
Q I changed the FCO of a Portable Station, but the display of the Portable Station still
shows the old FCO.
A
Turn the Portable Station off and back on again, to force it to re-register its location.
PC Programming Manual 91
2.7.1 Frequently Asked Questions (FAQ)