Filter
Top Products
Wink Signal Time-Out
Specifies the
length of time that the PBX waits to receive a wink signal after seizing a trunk. If a wink signal is
not received before this timer expires, the trunk is released.
Value Range
64 ´ n (n=1–128) ms
Maintenance Console Location
3.42 [1-1] Slot—Port Property - E1 Port
Programming Manual References
None
Feature Guide References
None
Start Signal Type
Selects the type of the start signal.
Value Range
Immediate: Sends the dialled digits to the trunk when the First Dial Timer expires.
Wink: Sends the dialled digits to the trunk when the wink signal is received.
Maintenance Console Location
3.42 [1-1] Slot—Port Property - E1 Port
Programming Manual References
None
Feature Guide References
None
Sending Caller ID to TIE
Specifies whether Caller ID information is sent when Channel Type on this screen is set to E&M-P or
E&M-C.
Value Range
No, Yes
Maintenance Console Location
3.42 [1-1] Slot—Port Property - E1 Port
PC Programming Manual 369
3.42 [1-1] Slot—Port Property - E1 Port