Filter
Top Products
3.15 [1-1] Slot—Port Property - Virtual IP Extension
Various settings can be programmed for each virtual IP extension port.
To change the status of virtual IP extension ports, click Command.
IP-PT Registration and De-registration
An IP-PT must be registered to the PBX by programming the PBX and IP-PT before it can be used.
Programming instructions for the PBX are given below.
It is possible to de-register the IP-PT later.
Preparation
Open 3.4 [1-1] Slot—Card Property - IPCMPR, and confirm that the IP addresses of the IPCMPR and DSP
cards, subnet mask address, and default gateway address are set.
Registration
Follow the steps below to register the IP-PT.
1. Connect the IP-PT to be registered to the network and, if necessary, the power supply.
2. Click Registration.
A dialogue
box will appear. Non-registered (available) extension numbers and names are displayed on the
left.
3. Highlight numbers and names and click the right arrow to select them for registration. Click Next.
4. If the registration is still in progress, the dialogue box will show "Registration Executing".
If the registration is successful, the dialogue box will show "Registration Completed". Click Close.
Once the IP-PT is successfully registered, the status of the IP-PT will update to show "Registered".
De-registration
Follow the steps below to de-register the IP-PT.
1. Click De-registration.
A dialogue box will appear. Registered extension numbers and names are displayed on the left.
2. Highlight numbers and names and click the right arrow to select them for de-registration. Click Next.
A dialogue box will appear.
3. Click Confirm.
• If the de-registration is successful, the dialogue box will show
"De-registration Succeed
".
• If the de-registration is unsuccessful, the dialogue box will show "De-registration Error".
De-registration will be terminated.
4. Click Close.
If the IP-PT is successfully de-registered, the status of the IP-PT will update to show "None".
Forced De-registration
Follow the steps below to forcibly de-register the IP-PT when normal de-registration has been unsuccessful
or IP address settings have been changed or deleted only on the IP-PT.
1. Click Forced De-registration.
A dialogue box will appear. Registered extension numbers and names are displayed on the left.
2. Highlight numbers and names and click the right arrow to select them for forced de-registration. Click
Next.
A dialogue box will appear.
180 PC Programming Manual
3.15 [1-1] Slot—Port Property - Virtual IP Extension