Filter
Top Products
5.3 [3-1-3] Caller ID Modification
The telephone numbers of incoming callers can be modified automatically according to preprogrammed
modification tables, and then recorded for calling back.
Leading Digits
After the caller’s number is modified by the Length of Digits Modification Tables or CLIP Modification Tables,
the PBX checks the leading digits of the modified number for an area code programmed in the Caller ID
Modification Table assigned to that trunk group. If it finds such a code, it removes digits and adds a number
to the
modified number. If this number is stored as a System Speed Dialling number, the caller’s name can be
shown on a PT display and the call can be routed to a certain extension (CLI destination). A maximum of 4
Caller ID Modification Tables, each containing 10 local/international call data and 1 long distance code, can
be programmed. Each trunk group can select a table for use. Select the desired table from the Modification
Table list.
If the modified number does not contain an area code programmed here, the PBX applies the Long Distance
Code settings to the modified number.
Area Code (for Local / International Call Data 1–10)
Specifies the leading number (area code) to look for in the incoming caller’s number.
Value Range
Max. 6 digits (consisting of 0–9, *, and #)
Maintenance Console Location
5.3 [3-1-3] Caller ID Modification
Programming Manual References
None
Feature Guide References
1.18.1 Caller ID
Removed Number of Digits
Specifies the number of digits to be removed from the beginning of the incoming caller’s number.
Value Range
0–9
Maintenance Console Location
5.3 [3-1-3] Caller ID Modification
Programming Manual References
5.1 [3-1-1] Trunk Group—TRG Settings— Caller ID Modification Table
8.1 [6-1] System Speed Dial
PC Programming Manual 529
5.3 [3-1-3] Caller ID Modification