Filter
Top Products
Registering individual portables / 79
P0881594 Issue 01 MICS-XC Norstar-Companion Installer Guide
5. Enter the five-digit ID code for the Base Station radio you
want to measure. The portable displays this ID followed by
the signal strength and the power mode, for example
03142 - 54 H. Hand-off does not occur as you move
between the cell boundaries. The link drops when you
move out of range.
In this example, the module is 03, the port is 14, and the
radio is 2. The signal strength measured by the Base
Station is -54 dBm, and the H indicates the portable is
transmitting in high-power mode (an L indicates low-
power mode).
6. To end the connection, press , or close the flap.
Registering the C3020 (Canada only)
The following section describes the procedures involved in
registering Companion C3020 portable telephones. To register
each portable with the Norstar system, you must do two things:
• Register the portables by entering the Registration
password on each one.
• Verify that the portable functions properly.
To register the C3020
1. On the Administration set, turn on registration in a general
programming session. See “Companion programming is
found under the System programming heading. It includes
the following subheadings:” on page 61.
1. On the portable, press , then press .
2. Press .
3. Check the portable’s display.
If the portable has space for another system, the display
shows Office n: Free.
p0881594.book Page 79 Tuesday, August 25, 1998 3:59 PM