Nortel Networks MICS-XC Telephone User Manual


 
26 / Installation
MICS-XC Norstar-Companion Installer Guide P0881594 Issue 01
Output connections
Feed the output pairs in through the bottom of the RPI and
route the pairs to the output connectors as shown in the
following illustration. If only one pair is used for powering a
Base Station, connect the power pair to -PWR(1) and
+PWR(1). If two pairs are used to power a Base Station,
connect one pair to -PWR(1) and +PWR(1), and the second
pair to -PWR(2) and +PWR(2).
Output connector pinout
Input connections
Feed the TCM input pairs from the ICS distribution frame
through the top of the RPI and route the pairs to the input
connectors (IBIX1 to IBIX4) as shown in the following
illustration. There may be fewer than 16 input pairs in any
given RPI installation.
Ensure both pairs have the same polarity.
Connecting two power pairs with opposing polarities
may damage the Base Station and RPI.
OBIXn
-PWR(1)
TCM
TCM
+PWR(1)
-PWR(2)
+PWR(2)
p0881594.book Page 26 Tuesday, August 25, 1998 3:59 PM