Filter
Top Products
Programming / 67
P0881594 Issue 01 MICS-XC Norstar-Companion Installer Guide
a cell neighbor (see the example under Cell nghbr), so it must
be a neighbor of cell 03 or 04.
System logical identifier (LID)
This setting allows you to change the code by which the
system identifies itself to portables and which the portables
use to request service from the system. The default setting is
randomly generated by the system at start-up. When the
system logical identifier (LID) is changed, all portables must
register again.
When changing the system LID, you can enter any
hexadecimal number between 0500 and FFFE. (Hexadecimal
characters can only range from 0 to 9 and A to E.)
There are only two reasons to modify the system LID.
• The site has multiple systems, and you want users to be
able to move from system to system without changing slots
on their portable telephones. All systems must be set to the
same system LID.
• Two systems that are located near each other were
accidentally assigned the same system LID. Users of one
system can access the other system. (This highly unlikely
situation could occur, for example, in an office building
occupied by multiple organizations.)
Use and CHANGE
to modify the System LID.
Changing system LID de-registers all
portables.
If you change the system LID, you invalidate the
registration of all the portables in the system.
Portables must be re-registered before they can
be used.
p0881594.book Page 67 Tuesday, August 25, 1998 3:59 PM