Filter
Top Products
Technical Configuration (T1/E1) MultiVOIP User Guide
158
T1 Parameter Definitions (cont’d)
ISDN Parameters
Field Name Values Description
Enable
ISDN-PRI
Y/N If digital connection is ISDN-
PRI type, this box should be
checked. When ISDN is
enabled, the “CAS Protocols”
field is grayed out (ISDN has its
own signaling method).
Terminal/
Network
either
“Terminal” or
“Network”
When “Terminal” is selected, it
indicates that the MultiVOIP
should emulate the subscriber
(terminal) side of the digital
connection. When “Network”
is selected, it indicates that the
MultiVOIP should emulate the
central office (network) side of
the digital connection.
Setting used for MultiVOIP
must be opposite to the setting
used in the PBX. For example,
if the PBX is set to “Terminal,”
then the MultiVOIP must be set
to “Network.”
Country see table, later
this chapter
Country in which MultiVOIP is
operating with ISDN.
Operator see table, later
this chapter
Indicates phone switch
manufacturer/model or refers
to telco so as to specify the
switching system in question.
ISDN is implemented
somewhat differently in
different switches.
Note on
Country &
Operator
options.
__ [ISDN implementation options
are shown, arranged by
country, in a table below – soon
after E1 Parameter Definitions.]