Filter
Top Products
5.17 [support] command
• -print: display current SUPPORT values configurations.
• -fstart: enable or disable fast start (support –fstart 0 / 1, 0 for disable and 1 for
enable.)
Note: When fast start function is enabled, if user wants to send DTMF message after
connection, IP Phone will send out Q.931 message. (Please refer to
sysconf –keypad command, which can only set keypad as q.931 message at this
time)
• -tunnel: enable or disable H.245 tunnel function.(support –tunnel 0 / 1 , 0 for
disable and 1 for enable)
• -h245fs: set if open H.245 separate channel after fast start or not. (support –h245fs
0 / 1 , 0 for open and 1 for not.)
5.18 [bureau] command
Type bureau can display commands below.
• -print: display bureau line information and configuration.
• -hold: set hold tone generation on or off. If other terminals support H.450 hold
function, and execute hold function when connecting with SP5100 IP Phone, user
will hear hold tone from SP5100 IP Phone. (0 for off,1 for on)
54