2 Operating Procedure – LCD Display
2.1 Initialize SP5100 IP Phone
1. When power on the SP5100 IP Phone, the LCD screen shows as below.
IP
Bo
Sy
IP
GK
The main LCD screen would be shown as similar as above. The GK word means the
5. fter pressing the PSTN button, the GK word will be replaced by PSTN. Then IP
ne
IP-Phone
PSTN 10:10 AM
Press Í or Î to enter configur mode then press OK Bottom to enter certain menu.
There are 6 selections for configuration.
)
-Phone
ard Start Booting
2. Wait around one minute until the SP5100 IP Phone finishes boot program
initialization.
3. User can see flashing greeting as below:
stem Initializing………
4. Then IP Phone get into standby mode:
-Phone
10:10:10 AM
SP5100 IP Phone is in Gatekeeper Mode, and when IP Phone is connected to SNTP
server, on LCD will show current time from SNTP server.
A
Phone is in PSTN Mode. Please notice that in PSTN mode user must plug PSTN li
in RJ-11 port.
10:
ation
1. System Configuration (mandatory, protected by password)
2. User Line Number (mandatory
3. Ring Configuration
4. Indicate Forward Type
5. Message Box
6. Phone Address Book
9