Filter
Top Products
System Set-up using FleetCP PC Programs
5.1.2 Pin Codes
The status of the PIN codes can be seen on the right side of
the status bar. If no PIN codes are entered, all locks will be
red and locked. Click the appropriate button to enter or
change a PIN code. See picture below. If a PIN is entered,
the lock will become unlocked and turn green. At the same
time a new logout button will appear next to the PIN code
buttons. Clicking this button resets the status of the all PIN
codes.
If a change to the configuration is made without entering a
PIN code first, a prompt will appear when the write button
is pressed, asking for the PIN. See below.
To read more about PIN codes see section 3.2 Use of PIN
Codes.
5
May 2005 69