Filter
Top Products
System Set-up using FleetCP PC Programs
5 PC Programs
5.1 System Set-up using FleetCP
System set-up can be managed from a PC program called
FleetCP, instead of from the handset. FleetCP can be
installed from the enclosed CD-ROM. The following pages
contain a short introduction to FleetCP. The picture below
shows the initial screen, when the program is started.
Connect the transceiver to PC using a standard RS-232.
When connected, clicking the red R button on the top
toolbar will read the current configuration from the
terminal. Clicking the red W button, will write any changes
to the terminal.
5
May 2005 67