Filter
Top Products
61
13. FM-3010 CONTROLLABLE MIC
13.14 Set Mode Programming
Set mode is used to change the condition of the transceiver’s
functions and the microphone’s own functions:
Transceiver’s functions—
scan mode (Normal or Priority), scan resume timer, weather
alert, Dualwatch/Tri-watch, DSC watch, transceiver’s beep
tone, internal speaker (transceiver), LCD contrast (trans-
ceiver), RF attenuation level, scrambler code and automatic
acknowledgement.
Microphone’s own functions—
beep tone function (microphone) and LCD contrast (micro-
phone).
In this section, instructions are for the microphone’s own func-
tions only. Refer to pgs. 37–40 for the setting of the other
functions. (Some functions cannot be selected from the FM-
3010.)
Entering Set mode
q Turn power OFF.
w While pushing [
16
]( ), turn power ON.
•After a beep emission, a Set mode item (in the channel comment in-
dicator and the condition in the channel number readout) is displayed.
e Push [
16
]( )to select the desired item, if necessary.
r Push [
YY
]
/
[
ZZ
] to select the desired condition of the item.
t Turn power OFF, then ON to exit Set mode.
•Beep tone “BEEP”
➥Push [
YY
] to turn ON, [
ZZ
] to turn OFF the beep output.
•LCD contrast “LCD CONTRAST”
➥Push [
YY
]
/
[
ZZ
] to adjust to a suitable LCD contrast.
Push
Push
9
9