Filter
Top Products
iv
ELECTRICAL SHOCK HAZARD
Do not open the equipment un-
less totally familiar with electri-
cal circuits and service manual.
Only qualified personal should work in-
side the equipment.
Be sure that the power supply is compatible
with the voltage rating of the equipment.
Connection of an incorrect power supply can cause fire or
equipment damage. The voltage rating of the equipment ap-
pears on the label above the power connector.
Turn off the power at the switchboard before
beginning the installation.
Fire or electrical shock can result if the power is left on.
DO NOT install the equipment where normal operation of
the vessel may be hindered or where it could cause bodily
injury.
RR
WARNING
DO NOT cut the DC power cable between the DC plug
and fuse holder. If an incorrect connection is made after cut-
ting, the equipment may be damaged.
RR
WARNING
Ground the equipment to pre-
vent electrical shock and mutual
interference.
Observe the following compass safe dis-
tances to prevent interference to a magnetic
compass:
RR
CAUTION
For the installer
Standard Steerling
compass compass
Transceiver 0.95 m 0.65 m