Filter
Top Products
4.Scan Operation
12
INT
25W
DUPTAG
INTL
INT
25W
DUPTAG
Normalscan
BUSY INT
25W
DUPTAG
Normalscan
Push
Scan starts. When a signal is received
[Example]: Starting a Normal scan.
4.2 Setting Tag Channels
For more efficient scanning, add desired channels as tag
channels or clear tag channels for unwanted channels. Chan-
nels not tagged will be skipped during scanning. Tag chan-
nels can be assigned to each channel group (U.S.A., Interna-
tional, Canada) independently.
q While pushing [
HI/LO
], push [
CH/WX
]( )one or
more times to select the desired channel group.
w Select the desired channel to be set as a tag channel.
e Push [
SCAN
]( )for 1 sec. to set the displayed channel
as a tag channel.
•“TAG” appears in the display.
r To cancel the tag channel setting, repeat step e.
•“TAG” disappears.
Convinient: Clearing (setting) all tagged channels
➥While pushing
[
[
HI/LO
HI/LO
]
], push
[
[
SCAN
SCAN
]
]
(
(
)
) for 3 sec. (until
a long beep changes to 2 short beeps) to clear all tag chan-
nels setting in the channel group.
•Repeat above procedure to set all tag channels.
4.3 Starting a Scan
Set scan type (Priority or Normal scan) and scan resume
timer in advance using Set mode. (p. 38)
q Set tag channels as described at left.
w Make sure the squelch is closed to start a scan.
e While pushing [
HI/LO
], push [
CH/WX
]( )one or
more times to select the channel group, if desired.
r
Push
[
SCAN
]
to start Priority or Normal scan.
•“Pri Scan 16” or “Normal Scan” appears in the function
display.
•When a signal is detected, scan pauses until the signal disap-
pears or resumes after pausing 5 sec. according to Set mode
setting. (Channel 16 is still monitored during Priority scan.)
•Rotate [
CHANNEL
] to check the scanning tag channels, to
change the scanning direction or resume the scan manually.
•“16” blinks and a beep tone sounds when a signal is received
on Channel 16 during Priority scan.
t To stop the scan, push [
SCAN
].
U/I/CDW
TAG
TAG
U/I/C
DW