Furuno FM-3000 Telephone User Manual


  Open as PDF
of 76
 
23
5.DSC Operation
5.6.3 Transmitting Group call
The Group call function allows you to transmit a DSC signal
to a specific group only.
q Push [
DSC/ENT
] to enter the DSC menu.
w Rotate [
CHANNEL
] to select “Group,” push [
DSC/ENT
].
e Rotate [
CHANNEL
] to select the desired pre-programmed
group address or “Manual Input,” push [
DSC/ENT
].
•The ID code for the Group call can be set in advance. (p. 13)
•When “Manual Input” is selected, set the 9-digit ID code
(must be set to ‘0’) for the group you wish to call by using
[
CHANNEL
].
-Push [
CH/WX
] or [
SCAN
] for cursor movement.
-After 9-digit is input, push [
DSC/ENT
] to set the ID code.
r Rotate [
CHANNEL
] to select a desired intership channel
or “Manual Input,” push [
DSC/ENT
].
•When “Manual Input” is selected, rotate [
CHANNEL
] to se-
lect the desired channel other than Channel 70, push [
DSC/ENT
].
t Push [
DSC/ENT
] to transmit the Group call.
•If Channel 70 is busy, the transceiver stands by until the channel
becomes clear.
y After the Group call has been transmitted, the display
changes to the previously selected channel.
u
Push and hold [
PTT
] to communicate your message to the
responding ship or push [
DSC/ENT
] to exit the condition.
Group
Completed
ToCall,
ToCancel
[other]
[DSC/ENT]
SelChannel
67
13
˘72
SelAddress
Smith Grp
ManualSet
˘Osaka Grp
SelItem
Individual
INDVACK
˘Group
 previous next