Filter
Top Products
486 Dialogic
®
Global Call IP Technology Guide — November 2007
Dialogic Corporation
Variance for SIP
The gc_SetConfigData( ) function can be used to enable and disable the optional
GCEV_INVOKE_XFER_ACCEPTED event on a line device basis. This event is only relevant
when the call transfer supplementary service is enabled, and is generated to notify the Transferor or
Transferring application (party A) that the Transferee or Transferred party (party B) has received
and accepted a call transfer request. As with other maskable call state events, the parameter set ID
IPSET_CALLINFO IPPARM_H245TUNNELING †††
Enumeration with one of the following values:
• IP_H245TUNNELINGON
• IP_H245TUNNELINGOFF
gc_AnswerCall( )
IPPARM_CONNECTIONMETHOD
Enumeration with one of the following values:
• IP_CONNECTIONMETHOD_FASTSTART
• IP_CONNECTIONMETHOD_SLOWSTART
IPPARM_FASTSTART_MANDATORY_H245CH
Enumeration with one of the following values:
• IP_FASTSTART_MANDATORY_H245CH_ON
• IP_FASTSTART_MANDATORY_H245CH_OFF
gc_AnswerCall( )
gc_MakeCall( )
IPSET_CONFIG IPPARM_OPERATING_MODE
Enumeration with one of the following values:
• IP_AUTOMATIC_MODE
• IP_MANUAL_MODE
gc_AnswerCall( )
gc_MakeCall( )
IPSET_DTMF IPPARM_SUPPORT_DTMF_BITMASK
Datatype: Uint8[ ]
IPPARM_DTMF_RFC2833_PAYLOAD_TYPE
Datatype: Uint8[ ]
gc_AnswerCall( )
gc_MakeCall( )
IPSET_VENDORINFO IPPARM_VENDOR_PRODUCT_ID
String, max. length =
MAX_PRODUCT_ID_LENGTH (32)
IPPARM_VENDOR_VERSION_ID
String, max. length =
MAX_VERSION_ID_LENGTH (32)
IPPARM_H221NONSTD
Datatype IP_H221NONSTANDARD.
gc_AnswerCall( )
gc_MakeCall( )
IPSET_EXTENSIONEVT_MSK GCACT_ADDMSK
Datatype: Uint8[ ]
GCACT_SETMSK
Datatype: Uint8[ ]
GCACT_SUBMSK
Datatype: Uint8[ ]
gc_AnswerCall( )
Table 40. Parameters Configurable Using gc_SetConfigData( ) When Using H.323 (Continued)
Set ID Parameter IDs Use Before †
† Information can be set in any state but it is only used in certain states. See the “variances” section for the specific function
for more information.
†† This is a system configuration parameter for the terminating side, not a call configuration parameter. It cannot be
overwritten by setting a new value in gc_SetUserInfo( ) or gc_MakeCall( ).
††† Applies to the configuration of tunneling for inbound calls only. See Section 4.1.3, “Enabling and Disabling H.245
Tunneling (H.323)”, on page 114 for more information.