Filter
Top Products
Clarity - INT9 A/D converter Using the INT9 card
18
3.2.2 Method Setup - Measurement
Fig. 11. Method Setup - Measurement
External Start/Stop
Enables control from an external signal.
Note: The Input used for an external Start from a
chromatograph can be set in the
System Configuration
dialog (see Fig. 4 on pg. 10).
Start Only
The external signal only starts an analysis.
Triggering the input will not influence the
acquisition in progress.
Start - Restart
The external signal terminates the analysis
in progress and at the same time starts a
new one. The first signal starts the analysis;
the second signal terminates it and at the
same time starts a new one - the so-called
continuous measurement.
Start - Stop
The external signal starts and stops an
analysis. The first signal starts the analysis;
the second signal stops it, etc.