Filter
Top Products
PHONE LINE MANAGER 16 X 4
25
7. Do you want to dial 9 or 0 to access an outside line ?
You can choose either 9 or 0 as the code for the user to dial when requesting an outside line.
6.2 Dialing “9” to Access Outside Lines
The system is preset so that users dial 9 to access an outside line and 0 to make an intercom call to the
Operator. You may want to change the 9 to a 0 if this is the standard in your area.
To access an outside line by dialing 0:
1. In the programming mode, lift the handset and enter 7801. Pause for confirmation tone. Hang up
or continue programming.
To access an outside line by dialing 9:
1. In the programming mode, lift the handset, enter 7800. Pause for confirmation tone. Hang up
or continue programming.
NOTE
If you configure the system so that “0” accesses an outside line, “9” will then directly dial
the operator. If “9” is the number for outside line access, then “0” will dial the operator.
6.3 Programming Outside Lines
Each outside line must be programmed separately. The programming procedure is simple if you take it step-
by-step. First, decide on the codes you want to enter for each line. Write the code for each of your choices in
the table provided on the next page. Then program one line at a time. The default settings are marked with
an asterisk (*).
1. In the programming mode, lift the handset and dial 739.
2. Enter the line number (1 to 4).
3. Enter the code for enabling the CO line and for Auto-Attendant (or DISA) operation.
*0 No DISA
1 DISA in Day-mode only
2 DISA in Night-mode only
3 DISA always
4 Disable this CO line
4. Enter the code for the desired dialing mode and switchhook (flashing) capability.
0 Pulse dialing, switchhook not allowed.
2 Tone (DTMF) dialing, switchhook not allowed.
4 Pulse dialing, switchhook allowed.
*6 Tone (DTMF) dialing, switchhook allowed.