Filter
Top Products
PHONE LINE MANAGER 16 X 4
15
• forwarding calls to another extension,
• and turning on or off the message lamp of another extension.
If Hunt Groups are used (see Chapter 10), the extension numbers 122, 133, 144, and 155 are reserved.
You may not assign an extension to use one of these numbers.
4.2 Programming the Extensions
The configuration settings for each extension must be programmed separately. The programming
procedure is simple if you take it step-by-step. First, decide on the codes you want to enter for each
extension. Write down the code for each of your choices. Then program one extension at a time. You
must complete all steps for each extension before starting on the next one. The “*” mark indicates the
default value of each setting.
1. In the programming mode, enter 75.
2. Enter the 2-digit extension number (00 to 15).
3. Enter the code for the phone type and features:
0 ordinary phone (with no special features)
* 1 ordinary phone + enable call hold retrieval
2 key phone
3 key phone + enable call hold retrieval
4 ordinary phone + rollover extension
5 ordinary phone + rollover extension + enable call hold retrieval
6 key phone + rollover extension
7 key phone + rollover extension + enable call hold retrieval
4. Enter the code for other features:
0 no additional features
* 1 enable call transfer/hold
2 enable call break-in
3 enable call transfer/hold + call break-in
4 enable emergency alarm
5 enable call transfer/hold + emergency alarm
6 enable call break-in + emergency alarm
7 enable call transfer/hold + call break-in + emergency alarm
5. Enter the code for paging and door phone assignment.