AT&T TL92420 Cordless Telephone User Manual


 
83
Appendix
Troubleshooting
I cannot dial out.
First try all the suggestions in I cannot get a dial tone above.
Make sure you have a dial tone before dialing. The cordless handset may
take a second or two to find the telephone base and produce a dial tone.
This is normal. Wait an extra second before dialing.
Eliminate any background noise. Noise from a television, radio or other
appliances may cause the phone to not dial out properly. If you cannot
eliminate the background noise, first try muting the cordless handset
before dialing, or dialing from another room in your home with less
background noise.
Disconnect the telephone base from the telephone wall jack and plug in a
working telephone. If the other phones in your home are having the same
problem, the problem is in your wiring or telephone service. Contact your
telephone service provider (charges may apply).
My cordless handset isn’t performing normally.
Make sure the power cord is securely plugged into the telephone base.
Plug the power adapter into a different, working electrical outlet not
controlled by a wall switch.
Move the cordless handset closer to the telephone base. You might have
moved out of range.
Reset the telephone base. Unplug the electrical power. Wait for 15
seconds then plug it back in. Allow up to one minute for the cordless
handset and telephone base to reset.
Other electronic products can cause interference to your cordless phone.
Try installing your phone as far away from these types of electronic
devices as possible: television sets, VCRs, or other cordless telephones.
The handset registration is unsuccessful.
Follow the steps below to re-register the handset.
1. Make sure the handset is out of the telephone base or charger and shows
NOT REGISTERED before you begin registration.
2. Press and hold /HANDSET LOCATOR for about four seconds (until the
red IN USE light on the telephone base is on) and then release the button.
3. Place the unregistered handset into telephone base or charger.
Refer to the Add and register a handset section on page 77 for details.