Filter
Top Products
38
Handset settings
Answering system settings
Remote access code
A two-digit security code is required to access the answering system
remotely from any touch tone telephone. The preset code is 19. You can
change the code to any number from 00 to 99.
To change the remote code:
Press MENU/SELECT on the handset in idle mode to enter
the main menu.
Use CID or DIR to scroll to Answering sys, then press
MENU/SELECT.
Use CID or DIR to scroll to Ans sys setup, then press
MENU/SELECT.
Press CID or DIR to scroll to Remote code, then press
MENU/SELECT.
Use the dialing keys (0-9) to enter a two-digit number
from 00-99, then press MENU/SELECT to confirm.
Press MUTE/DELETE to erase a digit.
Press and hold MUTE/DELETE to erase all digits.
Press CID to move the cursor to the left or DIR to the right.
Press MENU/SELECT to confirm your setting. You hear a confirmation tone.
Message alert tone
When the message alert tone is set to On, the telephone base beeps every
10 seconds to alert you of new messages. The tone stops when all new
messages have been reviewed. The default message alert setting is off.
To set the remote access code:
Press MENU/SELECT on the handset in idle mode to enter
the main menu.
Use CID or DIR to scroll to Answering sys, then press
MENU/SELECT.
Use CID or DIR to scroll to Ans sys setup, then press
MENU/SELECT.
Press CID or DIR to scroll to Msg alert tone, then
press MENU/SELECT.
Press CID or DIR to choose between On and Off.
Press MENU/SELECT to confirm your setting. You hear a confirmation tone.
1.
2.
3.
4.
5.
•
•
•
6.
1.
2.
3.
4.
5.
6.
ANS SYS SETUP
Call screening
# of rings
Remote code
Msg alert tone
REMOTE CODE
19
ANS SYS SETUP
Call screening
# of rings
Remote code
Msg alert tone
MSG ALERT TONE
On
Off