Filter
Top Products
Operating and Programming
5071A Command References
1-9
5071A Command References
This section describes the additions, changes, and deletions to the
information that appears in chapter 5 of the 5071A Operating and
Programming manual.
5071A Command Summary
SCPI Commands
Table 5-2. SCPI Command Summary
The response form for
DIAGnostic:STATus:SUPPLY? command has
changed:
AC/DC/LOW
The operation of [SOURce]:PTIMe:SYNC with the REAR parameter will
always result in sync timed out with arming terminated after 1.5
seconds,
SCPI Subsystem Commands
The changes for the 5071A Command Summary above also apply to the
corresponding SCPI Subsystem Command references,
Status Reporting
Table 5-5. SCPI OPERation Status Register
In table 5-5. Bit 9 (On Battery) will always be zero (0).
Rear-Panel Status Output Operation
Status Output Programming
The actual use of SCPI OPERation status register Bit 9 as a
programmed condition will never cause a status output port state
change.
The programming examples shown will work only when the 48 Vdc
power option is absent, but are still valid to describe the technique for
programming the status output port.
Option 048:
Any TCO Option:
Option 048:
Option 048: