Making Calls
98 41-001523-00 REV00 – 04.2014
Using Handsfree Speakerphone
The handsfree feature allows you to speak to someone without using the handset or headset. Your phone must be in
either the Speaker or Speaker/Headset audio mode. For more information about setting the audio mode on your
phone, see “Audio Mode”
on page 24.
• To dial using handsfree, first press and enter a number at the dial tone.
• To answer a call on your phone using handsfree, press or the line/call appearance button.
• If you are in Speaker audio mode, lift the handset and press to switch between handsfree and handset.
• If you are in Speaker/Headset audio mode, press to switch between handsfree and headset.
• When the handset is on hook, press to disconnect the call.
Using a Headset
The 6865i accepts headsets through the modular RJ22 jack on the back of the phone. Contact your telephone equip-
ment retailer or distributor to purchase a compatible headset.
Volume Controls for the Headset Microphone
On the 6865i, there are three options for the headset microphone volume: Low, Medium, and High. For information
about configuring the headset microphone volume, see “Headset Mic Volume” on page 25
.
Making and Receiving Calls Using a Headset
IP Phone UI
Note:
When handsfree is on, the speaker light turns on.
Important!
• The headset port is for headset use only. Plugging any other devices into this port may cause damage to the phone
andwill void your warranty.
• Customers should read and observe all safety recommendations contained in headset operating guides when using
any headset.
IP Phone UI
1. Ensure that you have selected a headset audio mode (see “Audio Mode” on page 24.
2. Turn the phone over and locate the headset jack marked f.
If you have a headset with an RJ9/RJ22 4-pin connector, insert the headset cord into the jack until it clicks into place.
If you have a DHSG/EHS headset with an RJ45 6-pin or 8-pin connector, remove the plastic headset jack adapter and
then insert the cord into the jack until it clicks into place.
Note:
See the Aastra 6865i SIP IP Phone Installation Guide for more information.
3. Press the key to obtain a dial tone or to answer an incoming call. Depending on the audio mode selected
from the Options List, a dial tone or an incoming call is received on either the headset or the handsfree speakerphone.
4. Press the key to end the call.
