Filter
Top Products
Chapter 13 System
V300 User’s Guide
136
The following table describes the labels in this screen.
13.2 Time Setting Screen
To change your V300’s time and date, click Maintenance > System > Time Setting. The
screen appears as shown. Use this screen to configure the V300’s time based on your local
time zone.
Table 57 Maintenance > System > General
LABEL DESCRIPTION
System Setup
System Name System Name is a unique name to identify the V300 in an Ethernet network. It is
recommended you enter your computer’s “Computer name” in this field.
This name can be up to 30 alphanumeric characters long. Spaces are not allowed,
but dashes “-” and underscores "_" are accepted.
Domain Name Enter the domain name (if you know it) here. If you leave this field blank, the ISP
may assign a domain name via DHCP.
The domain name entered by you is given priority over the ISP assigned domain
name.
Administrator
Inactivity
Timer
Type how many seconds a management session can be left idle before the
session times out. After it times out you have to log in with your password again.
Very long idle timeouts may have security risks. The default is 0 seconds, which
means a management session never times out, no matter how long it has been left
idle.
Password Setup
Old Password Type in your existing system password (“1234” is the default password).
New
Password
Type your new system password.
Note: The new password must be between 4 and 8 numerals (0 ~
9) long. Letters, spaces and other characters are not
allowed.
Note that as you type a password, the screen displays an asterisk (*) for each
character you type.
Retype to
Confirm
Retype your new system password for confirmation.
Apply Click this to save your changes back to the device.
Reset Click this to reload the previous configuration for this screen.