Filter
Top Products
Chapter 10 SIP Account Setup
V300 User’s Guide
116
DTMF Mode Control how the V300 handles the alphanumeric keypad tones. You should use
the same mode your VoIP service provider uses.
RFC 2833 - send the DTMF tones in RTP packets
PCM - send the DTMF tones in the voice data stream. This method works best
when you are using a codec that does not use compression (like G.711). Codecs
that use compression (like G.729) can distort the tones.
SIP INFO - send the DTMF tones in SIP messages.
RFC 2833 like - send the information in SIP messages but with an RTP payload.
STUN
Enable Select this if all of the following conditions are satisfied.
• There is a NAT router between the V300 and the SIP server.
• The NAT router is not a SIP ALG.
• Your VoIP service provider gave you an IP address or domain name for a
STUN server.
Otherwise, clear this field.
Server
Address
Enter the IP address or domain name of the STUN server provided by your VoIP
service provider.
Server Port Enter the STUN server’s listening port, if your VoIP service provider gave you one.
Otherwise, keep the default value.
Outbound Proxy
Enable Select this if your service provider has a SIP outbound server to handle voice
calls. This allows the V300 to work with any type of NAT router and eliminates the
need for STUN or a SIP ALG. Turn off any SIP ALG on a NAT router in front of the
V300 to keep it from retranslating the IP address (since this is already handled by
the outbound proxy server.
Server
address
Enter the IP address or domain name of the SIP outbound proxy server.
Server Port Enter the outbound proxy server’s listening port, if your VoIP service provider gave
you one. Otherwise, keep the default value.
NAT Keep Alive
Active Select this to stop NAT routers between the V300 and SIP server (a SIP proxy
server or outbound proxy server) from dropping the SIP session. The V300 does
this by sending SIP notify messages to the SIP server based on the specified
interval.
Keep Alive
Interval
Enter how often (in seconds) the V300 should send SIP notify messages to the
SIP server.
MWI (Message
Waiting
Indication)
Enable Select this if you want to hear a waiting (beeping) dial tone on your phone when
you have at least one voice message. Your VoIP service provider must support
this feature.
Expiration
Time
Keep the default value, unless your VoIP service provider tells you to change it.
Enter the number of seconds the SIP server should provide the message waiting
service each time the V300 subscribes to the service. Before this time passes, the
V300 automatically subscribes again.
Call Forward
Enable Select this if you want the V300 to use the call forwarding rules you set up in the
VoIP > Phone Book > Call Forward screen.
RingBack Active
Table 47 VoIP > SIP > SIP Settings > Advanced Setup (continued)
LABEL DESCRIPTION