Filter
Top Products
9LHZ6RQLF3RFNHW3&9
6HWWLQJWKH%DWWHU\6ZLWFK
The switch on the back of your Pocket PC V37 should be switched to the ON
(down) position. If this is not the case, please set it to ON.
Make sure that the V37 is turned off.
Unscrew the cap at the top of the stylus. Use the pointed tip of the cap to
slide the battery switch to the ON (down) position.
The Notification indicator will flash red for approximately 30 seconds, and
then your V37 will automatically turn on and display the Welcome Wizard
screen.
IMPORTANT: Keep the battery switch set to ON (down position) unless
you need to restore factory defaults.
&KDUJLQJWKH%DWWHU\
Connect your V37 to an AC power source.
Plug the V37 into the USB cradle.
NOTE: You can also connect the V37 directly to the AC adapter without using
the USB cradle. For more information see “Battery Charging Options” in this
chapter.
Plug the appropriate end of the AC adapter into the power connector on the
USB cable.
NOTE: For information about battery replacement, see page 82.