Filter
Top Products
50
Resetting the Handset Without the Base
If your original base is not available for some reason, you can still reset the handset and use it with another base.
Press and hold 1) [
] and [#] for at least ve seconds.
Move the cursor to select BASEUNAVAILABLE and then press 2) [select/
]. BASE UNAVAILABLE appears.
Move the cursor to select YES, and then press 3) [select/
]. You hear a conrmation tone, and the handset
deletes its own base information without contacting the base. The handset displays HANDSET NOT
REGISTERED-PLACE HANDSET ON BASE TO REGISTER. SEE YOUR OWNER'S MANUAL FOR HELP.
Register the handset to the new base (see Registering Accessory Handsets on 4) page 20).
Changing the Digital Security Code
The digital security code is an identication code used to connect the handset and the base. Your unit ships from the
manufacturer with a preset security code. Resetting this code is not normally necessary. In the rare situation that you
suspect another cordless telephone is using the same security code or if you are instructed to change this code by a
manufacturer’s Call Center Representative, you can change the code. To change the digital security code:
Reset all of your handsets (see Resetting the Handset on 1) page 49).
Re-register each handset (see Registering Accessory Handsets on 2) page 20).
Traveling Out of Range
During a call, if you move your handset too far from your base, noise may increase. If you pass the range limit of the
base, the handset will beep, display OUT OF RANGE, and then go to standby. The base will maintain the connection
for thirty seconds after the handset goes out of range. If you move the handset back within range of the base within
thirty seconds, press [
/ash] or [ ] to pick up the call again.