Filter
Top Products
[ 46 ]
Setting the ring time
The ring time setting allows you to set the number of rings the caller hears before
your answering system plays the outgoing message. You can set the ring time
to answer after four, six, nine rings. If you enable the Toll Saver (TS setting), the
answering system picks up after six rings if you have new messages, and after
nine rings if there are none. This way, if you make a long distance call to check
your messages, you can hang up after the seventh ring to avoid billing charges.
1) Press
clock/MENU three times.
The current ring time setting (
4, 6, 9, (Toll saver)) appears on the base and
it is announced.
2) Press
skip/SELECT or repeat/SELECT until the desired ring time ap-
pears.
3) Press
SET to select the new ring time.
A confirmation tone sounds, system announces the new ring time.
Selecting the message record time
You have three record time options. The options “1 minute” or “4 minutes” set
the duration for recording the incoming messages. “Announce only” answers the
call with the preset greeting or your personal greeting but prevents the caller from
leaving a message.
1) Press
clock/MENU four times.
The current recording time (
1 minute, 4 minutes, A (Announce only)) appears
on the base and it is announced.
2) Press
skip/SELECT or repeat/SELECT until the desired message
record time appears.
3) Press
SET to select the new recording time.
A confirmation tone sounds, system announces the new record time.