Filter
Top Products
[ 36 ]
CHAIN DIALING
The memory locations in the handset are not limited to phone numbers. You
can also store a group of numbers (up to 20 digits), that you need to enter
once your call connects. This is referred to as Chain Dialing.
An example of this is a bank account number. Store the account or special
number in one of the phonebook locations. (Refer to “Storing Phone
Numbers, Names, Distinctive Rings and Speed Dial” on page 29.) When you
call your bank and you are prompted to enter the account number, scroll
through your phonebook locations until you find your account number, and
then press .
MEMORY DIALING (BASE ONLY)
You can store 10 phone numbers in the base, and make calls with memory
dialing from the base.
Storing Phone Numbers
1) Press mem in standby mode.
2) Enter the number you wish to store. (The number cannot exceed 20
digits.)
3) Press mem. Enter the memory location number (0-9) on the key-
pad.
You will hear a confirmation tone.
Making Calls with Memory Dialing
1) Press in standby mode.
2) Press mem. Enter the memory location number (0-9) to dial the number.
Deleting the Stored Data
1) Press mem in standby mode.
2) Press mem again.
3) Enter the memory location number (0-9) you wish to delete.
You will hear a confirmation tone.
• The 10 memory
locations in
the base are
independent from
the handset.
• If you have not
pressed any key
for 30 seconds, the
phone returns to
standby mode.
redial/pause