Filter
Top Products
THE INTEGRATED ANSWERING DEVICE [ 51]
THE INTEGRATED
ANSWERING DEVICE
5) After the command has finished, you hear intermittent beeps indicating that the system
is in the command waiting mode. You may enter another command at this time from the
chart above.
6) When you are finished, hang up to exit the system. The answering system automatically
returns to standby.
Turn on the answering system remotely
If you have forgotten to turn On your answering system, you can turn it On remotely from
any touch-tone telephone.
1) Call your telephone number.
2) Wait ten rings until the system answers. You hear a beep.
3) Press # and then enter your PIN code within 2 seconds. The answering system announces
the day and time, and the number of messages stored in memory. You hear “To play
incoming messages, press pound two. For help, press pound zero”.
4) Press # then 6 to turn the answering system On.
5) Hang up the phone and subsequent calls will be answered by the system.
Remote access with the handset
You can check your new incoming messages, skip, repeat, or delete
your incoming messages with the handset. For example, you can
install the answering system in the living room, and check your
incoming message from a bedroom with the handset.
• If you press end before the answering system answers, the phone will
return to standby.
• When the answering system does not answer within 7 seconds, you hear a
beep and the phone will return to standby.
• The base’s keypad is disable during remote operation.
• When you receive a call, the remote operation is canceled.
• You can change the handset volume and channel during a remote operation.
• During the remote operation “” appears on the base.
UC777BH(TRU4485) OM 4/9/02 1:48 PM Page 51