Filter
Top Products
Installing the Base Unit on a Desk or Tabletop
NOTE: Refer to the foldout located in the back of this Operating Guide to
help familiarize you with the controls of your cordless phone.
1. Place the Base Unit on
a desk or tabletop, and
plug one end of the
Telephone Line Cord
(supplied) into the
“
LINE IN
” jack on the
Base.
2. Plug the other end of
the Telephone Line
Cord into the telephone
wall jack.
3. Plug the AC Adapter
cord into the AC
Adapter input jack on
the Base Unit.
(
Note:
Use only the AC Adapter supplied with the
EXP 9100
.
)
4. Plug the AC Adapter into a standard 120V AC wall outlet.
5. Route the power cord where it will not create a trip hazard, or where it
could become chafed and create a fire or other electrical hazards.
The unique design of your
EXP 9100
allows you to place the Handset on the
Base Unit either face down or in an upright position. Also, you may extend the
legs on the bottom of the Base Unit, placing it at an angle for better visibility of
the LEDs (See the Base Unit Fold-out illustration). Remove the Handset
Support in the charging cradle so the handset remains in a stable, upright
position. The Battery Pack in the Handset automatically recharges in either
position.
8