Filter
Top Products
Using Your EXP 9100
NOTE: Refer to the foldout located in the back of this Operating Guide to
help familiarize you with the features of your cordless phone.
Preparing the Base Unit and Handset
1. On the Base Unit, select either Pulse Dialing or Tone Dialing, depending
on your local service.
2. Set the Base Unit
RINGER
/
VOLUME
switch to either “
LO
” or “
HI
” enabling
the Base Unit to ring when a call or page is received.
3. Set the Handset
RING/BATT SAVE
switch so the Handset will ring when
receiving a call.
NOTE: The
TALK
LED and keypad lights flash when the Handset receives a
call regardless of the
RING/BATT SAVE
switch position.
4. Press the
FLASH
/R. TONE
button on the Handset to select either of two
ringer sounds. (
Note:
This sets the ringer tone only when the phone is
not in use.
)
5. Press the
VOL
/
R. VOL
button on the Handset to select either high,
medium, or low ringer volume. (
Note:
This sets the ringer volume only
when the phone is not in use.
)
During a Call
Handset Earpiece Volume:
Press
VOL
/
R. VOL
on the Handset to select a loud or soft volume level in
the Handset earpiece.
Mute Mode:
Press
MUTE
to turn off the Handset’s microphone. The
MUTE
LED lights
to show Mute Mode is active. Use this feature to consult another person
in the room without the caller hearing you.
Out of Range Indicator:
When the Handset is reaching the end of the
EXP 9100
’s range limit, a
beep sounds in the earphone every four seconds. If the Handset goes
farther out of range, the warning beeps every 1.5 seconds. You must
go back into range within 20 seconds or the call will be dropped.
Keypad Lights:
The Handset’s Keypad Lights flash when a call is received and remain lit
for 10 seconds. Also, pressing any button on the Handset turns on the
Keypad Lights for 10 seconds.
14