Filter
Top Products
Mounting on a Standard Wall Plate
1. Plug one end of the
Telephone Line Cord
(supplied) into the “
LINE IN
”
jack on the top of the Base
Unit. Lay the cord inside the
molded channel on the
bottom of the Wall Mount
Adapter connected to the
Base Unit. (Put any excess
line cord inside the Wall
Mount Adapter.)
2. Plug the other end of the
Telephone Line Cord into
the telephone wall jack.
3. Plug the AC Adapter cord
into the AC Adapter input
jack on the Base Unit.
(Note:
Use only the AC
Adapter supplied with the
EXP 9100
.
) Place the cord inside the molded
channel on the Wall Mount Adapter connected to the Base Unit.
4. Place the Base Unit on the two posts of the wall plate and slide
downward to secure. Then hang the Handset on the Base Unit.
5. Plug the AC Adapter into a standard 120V AC wall outlet.
6. Route the power cord where it will not create a trip hazard, or where it
will not become chafed and create a fire or other electrical hazards.
If you do not have a standard wall plate, you can mount the Base Unit directly
on a wall.
Mounting Directly on a Wall
1. Carefully select a location away from electrical cables, pipes, or other
items behind the mounting location that could cause a hazard when
inserting screws into the wall.
2. Insert the two mounting screws 3
5
⁄
16
inches apart vertically, allowing
about
1
⁄
5
of an inch between the wall and screw heads for mounting the
phone. Make sure the screws are securely fastened, and that the wall
material is capable of supporting the weight of the Base Unit; otherwise,
damage to the Base Unit could result.
3. Plug one end of the Telephone Line Cord (supplied) into the “
LINE IN
”
jack on the Base Unit. Lay the cord inside the molding on the Wall
Mount Adapter connected to the Base Unit.
10