Filter
Top Products
Charging the Handset’s Battery Pack
The rechargeable Nickel-Cadmium Battery Pack must be fully charged before
using your EXP 9100 for the first time. (Note:
Allow the unit to charge without
interruption for 5-7 hours.
)
1. Place the Handset on the Base Unit.
2. Make sure the
CHARGE
LED lights.
If the
CHARGE
LED does not light, check to see that the AC Adapter is
plugged in.
Charging Extra Battery Packs
The Base Unit of your EXP 9100 is equipped with a Spare Battery Charger for
charging an extra Battery Pack.
1. Press the door to open
the Spare Battery
Charger.
2. Slide in the
Nickel-Cadmium Battery
Pack so it rests on top of
the ribbon. (Note:
The
Battery Pack is keyed to
fit so the electrical
contacts touch the Spare
Battery Charger’s
electrical contacts.
)
The
BATTERY CHARGE
LED should light. If the
BATTERY CHARGE
LED
does not light, check to
see that the AC Adapter
is plugged in.
3 Press the door to close
the compartment.
Note: Allow the Battery Pack to charge without interruption for 5-7 hours.
When charging is complete, use the ribbon to remove the Battery
Pack from the Spare Battery Charger.
12