Filter
Top Products
Storing Mixed Tone/Pulse numbers:
If your Base Unit is set up for Pulse Dialing, you can store a mixed mode
number (up to 16 digits) to easily access long distance services or other
services requiring Tone inputs.
1. Follow steps 1 and 2 in “Storing a Number,” then:
2. Enter the number to be dialed in Pulse Mode.
3. Press the
TONE
button on the Handset
(NOTE:
The
TONE
button counts as one digit.
)
4. Enter the number to be dialed in Tone Mode.If desired, press
RDL/P
to
enter delays between numbers.
5. Follow steps 4 and 5 in “Storing a Number.”
Example: Store 555-1234, plus tone number 765-4321 in memory
location 18:
a. Press
MEMO
b. Press
5551234
c. Press
RDL/P
(To enter delay between numbers)
d. Press
TONE
(Switches Handset to Tone Mode; counts as one digit)
e. Press
7654321
(Number entered in Tone Mode)
f. Press
MEMO
g. Press
18
Handset beeps confirmation and the
TALK
LED goes out.
Erasing a Stored Number
1. Remove the Handset from the Base Unit.
2Press
MEMO
twice
.
3. Press the memory location number or the
ONE-TOUCH DIALING
button you
want to clear. You will hear a long beep confirming that you have
erased the number.
Using your EXP 9100 Intercom
NOTE: The
RING ON/BATT SAVE
switch on the Handset must be in the
“
RING ON
” position.
The Base Unit
RINGER/VOLUME
switch must be set to either
“
LO
” or “
HI
”.
Paging from the Base Unit
1. Press
INT’COM
. (If no answer, press
INT’COM
again to disconnect.)
2. Press
TALK
or
INT’COM
on the Handset to answer the page.
Speak into the mouthpiece.
3. To turn off the Intercom, press
INT’COM
on the Base Unit
— OR —
Press
TALK
or
INT’COM
on the Handset.
18