Filter
Top Products
If the Base Unit loses power while the Handset is off the Base, the Digital Code
may be erased. When this happens, the Handset will not function. To restore
the Digital Code:
1. Remove the Handset from the Base Unit (if it is on the Base Unit).
2. Restore power to the Base Unit.
3. Place the Handset back on the Base Unit.
The
CHARGE
LED will blink twice to indicate that the Digital Security Code is set.
NOTE: It may take up to 5 seconds to establish contact between the
Handset and Base Unit and reset the Digital Security Code.
Auto Channel Scan and Auto Channel Change
During a call, your
EXP 9100
constantly monitors the noise level of the channel.
If the channel becomes too noisy, the unit automatically switches to a clearer
channel to maintain the best transmission quality.
Spread Spectrum Technology
Your
EXP 9100
uses Spread Spectrum Technology which provides a digital link
between the Base Unit and Handset. This advancement results in unparalleled
security, virtually eliminating any chance of outside monitoring, and greatly
improves noise reduction for top-quality sound in your cordless phone.
Auto Power Control
The
EXP 9100
automatically sets the Handset RF power level, depending on
the distance from the Base Unit. When the Handset is near the Base Unit, the
RF power level is low. When the Handset is at a greater distance from the
Base Unit, the RF power level is set automatically to high. This provides the
clearest possible communications while making the most efficient use of the
battery power.
6