Uniden BCD536HP Two-Way Radio User Manual


 
1
IMPORTANT INFORMATION
THE FCC WANTS YOU TO KNOW
IMPORTANT! This scanning radio has been manufactured so that it will not tune to the radio
frequencies assigned by the FCC for cellular telephone usage. The Electronic Communications
Privacy Act of 1986, as amended, makes it a federal crime to intentionally intercept cellular or
cordless telephone transmissions or to market this radio when altered to receive them. The
installation, possession, or use of this scanning radio in a motor vehicle may be prohibited,
regulated, or require a permit in certain states, cities, and/or local jurisdictions. Your local law
enforcement ofcials should be able to provide you with information regarding the laws in your
community.
Caution - FCC RF Exposure Requirements
Transmitter operating conditions: The antenna(s) used for this transmitter must be
installed to provide a separation distance of at least 7.8 in. (20 cm) from all persons
and must not be collocated or operating in conjunction with any other antenna or
transmitter
MODIFICATION NOTICE
Changes or modications to this product not expressly approved by Uniden, or operation of this
product in any way other than as detailed by this Users Guide, could void your authority to operate
this product.
PART 15 INFORMATION
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.