Filter
Top Products
27
10 sec - Turns the backlight on for 10 seconds when you press .
30 sec - Turns the backlight on for 30 seconds when you press
.
60 sec - Turns the backlight on for 30 seconds when you press
.
Infinite - The backlight always stays on.
Set Dimmer (BCD436HP Only)
High, Middle, or Low
Set Dimmer (BCD536HP Only)
Manual (For non-vehicle use) - High, Middle, Low, or Off.
Note: You can also toggle the backlight brightness by pressing Vol.
Auto (For vehicle use)
+ Polarity - If the orange wire gets 12V when you turn on the headlights.
- Polarity - If the orange wire is switched to chassis ground when you turn on the
headlights.
Adjust Contrast – This setting controls the displays contrast.
Contrast 1-15
Display Unit ID – Allows you view the unit ID of the radio currently transmitting on Motorola,
EDACS, and APCO P25 systems.
On or Off
Set ID Format – Sets the ID display format for the System.
Set ID Format (Mot/P25)
Decimal Format or Hex Format. The default setting is Decimal.
Set ID Format (EDACS)
AFS Format or Decimal Format. The default setting is AFS.
Set Upside-Down (BCD536HP Only) – This allows you to reverse the display so you can mount
the scanner upside-down and hear the speaker from the top. The default setting is Off.
On or Off
Selecting 3-Line Display Mode
Hold on any channel and press Func then 9(DISP). Press Channel to resume.
3-Line Display O