Filter
Top Products
45
DEPARTMENT OPTIONS
Edit Name Set Location Information Delete Department
Edit Channel Set Avoid New Department
Edit Name
See Data Naming.
Edit Channel
See Channel Options.
Set Location Information – This allows you program a location for the Department to use with
Location Control enabled or with a GPS. You can program a circle with a radial range or multiple
rectangles as a location.
See Set Up GPS rst.
Circle
Set Latitude
Enter the latitude. Press ./no to toggle N or S, and press E/yes.
Set Longitude
Enter the longitude. Press ./no to toggle E or W, and press E/yes.
Set Range See also Understanding Range.
0-6000
Rectangles
New Rectangle
Latitude - Top Left
Enter the latitude. Press ./no to toggle N or S, and press E/yes.
Longitude - Top Left
Enter the longitude. Press ./no to toggle E or W, and press E/yes.
Latitude - Bottom Right
Enter the latitude. Press ./no to toggle N or S, and press E/yes.
Longitude - Bottom Right
Enter the longitude. Press ./no to toggle E or W, and press E/yes.
Stored Rectangle
Edit Rectangle See Rectangles above.
Delete Rectangle
At Confirm Delete? press E/yes or ./no.
Set Avoid – This determines whether a Department will be scanned or not. Temporary Avoids
cancel when you cycle power.
The default setting is Stop Avoiding.
Stop Avoiding, Temporary Avoid, or Permanent Avoid
See also Scan Avoids.
Delete Department – Deletes the Department.
At Confirm Delete? press E/yes or ./no.
New Department – See New Department.