Filter
Top Products
2. Press the Autodial (ADL)
access key that you want to
program.
3. Press the desired line
appearance key.
4. Enter any applicable trunk
access code or Least Cost
Routing (LCR) code.
5. Dial the digits of the desired
number or code to be
programmed on the ADL key.
6. To designate the call as a
voice call, press the Voice
Calling (VC) access key.
7. To program another ADL key,
follow steps 2 ~ 6.
8. When all ADL keys are
programmed, press the PRGM
key.
To Place a Call via an Autodial
Key:
1. Press the desired line
appearance key.
2. Dial any digits that you want to
precede the digits
programmed onto an ADL key.
3. Press the desired ADL key.
4. To designate the call as a
voice call, press the VC key.
The ADL LED will flash red.
A line appearance key should be pressed only if you want the call to be
placed over a line other than the line designated by your telephone's line
preference type.
Any entered codes will be included as part of the Autodial sequence.
Display telephones will display the entered codes.
Display telephones will display the dialed digits.
Pressing the VC key will register Voice Calling as part of the Autodial
sequence. Voice Calling applies only to station-to-station calls.
Your telephone will be taken out of Program Mode.
A line appearance key should be pressed if there is no line selection
programmed into an Autodial sequence, or if you want to use a line other
than that designated by your telephone’s line preference type.
Dialed digits can be trunk group access codes, account codes, etc.
Display telephones will display the dialed digits.
Display telephones will display any digits associated with the Autodial
sequence.
The VC key should be pressed if there is no Voice Calling designation
programmed into an Autodial sequence and you want the call to voice
call a station.
PERCEPTION 4000 FEATURE OPERATION
4-6