TOA Electronics CP-66 Intercom System User Manual


 
Continuous Calling Tone
When there is an incoming call to the specified station,
a calling tone is sounded continuously at the called station.
The continuous calling tone stops if the called party presses
1. Use this function when it is difficult to hear a brief
single tone due to high background noise. Any station
can be so made as to be called by the continuous calling
tone, but No. 200 programming is required for such a
station (refer to Installation Handbook for EXES-6000
CP-66).
2. If the calling party presses the key while the
continuous calling tone is being sounded, the continuous
calling tone stops to allow the caller's voice call to go
through. Releasing the key restores the continuous
calling tone.
3. If either party continuously presses the key dur-
ing the normal two-way conversation, this makes a one-
way conversation from the party who pressed the
key. Releasing the key reverses the one-way
conversation flow and the other party has a dominance
(Press-to-Talk).
Notes.
1. In the NP type system that has no Privacy function,
the station can be called by the continuous calling
tone if its Privacy switch is set to ON. This function
by No. 200 programming is, therefore, used in the PV
type system having the Privacy function or for the
HF-670M industrial type station equipped with no
Privacy switch.
2. The following stations can be called by the continuous
calling tone:
(1) Stations in the "NP" type system or specified
substations in the "PV" type system.
(2) Stations registered for continuous calling tone by
No. 200 programming.
< Station vs. calling tone>
Continuous calling call
Continuous calling tone
Continuous calling tone
Call
Any key other than
"PV" Type
"NP" Type
Non -programmed station (standard)
Programmed station
Handset programmed station
Non -programmed station (standard)
Programmed station
Responding to a call made by continuous calling tone
Continuous calling tone
-
Single "trill" calling tone
(Call is put through immediately after
calling tone)
Continuous calling tone
Depress any dial key other than
key.
Privacy tone
Continuous calling tone
Continuous calling tone
Continuous calling tone
1 . Depress only dial key other than
key.
2. Pick up a handset.
3. Shift Privacy switch to OFF.
Type of system
Type of station
(Specific station provided with
"continuous calling tone" function by
station No.200 programming)
Type of calling tone
Privacy switch in OFF position
Privacy switch in ON position
— 31 —
Single "trill" calling tone
(Call is put through immediately
after calling tone)
Privacy tone