TOA Electronics CP-66 Intercom System User Manual


 
Functions: EXES-6000 CP-66
Notes.
1. XX/YY indicates to select either XX (Function) or
YY (Function).
2. Not all circles in The Switch Selection table
correspond to the DIP switches of the CP unit.
*1: "PV" (system with Privacy function) Type: with the
Privacy switch in the ON position, a brief Privacy
Tone sounds.
"NP" (system without Privacy function) Type: A
station may be called by the continuous calling tone
when the Privacy switch is placed in the ON position.
*2: When a hands-free station without handset is called
by the continuous calling tone, conversation may
start by touching any key
*3: Using the Press-to-talk control function reduces the
maximum number of paging zone to All call + 23
zones (7 zones).
*4: This function may not be used if numbers 100
through 199 are used in the Station Numbering
Schedule. Either "Personal number call" or "Personal
number paging" may be selected.
*5: Additional equipment is required for paging.
*6: Either "Executive Priority" or "Highest Executive
Priority" may be selected.
*7: Each zone of paging provides Station paging and/or
PA paging.
*8: It is necessary to respond only by dialing (with-
out zone No.).
*9: It is possible to make a paging call and its response
between the local exchange and the remote extension
exchange. However, a response to the zone paging is
possible only from a station connected to the ex-
change having the paged zone.
*10: Station numbers of each exchange can be changed
freely within the range of "Selectable numbering
schedule of each exchange".
*11: Calling tone: 0.3 sec (Trill note tone)/0.2 sec (Single
note tone)/none.
Paging pre-paging tone: 2 sec/1 sec/none.
*12: Selects whether or not the indication of the calling
party station continuously lights up, after the calling
party has cancelled the call to a line which is busy or
in the privacy mode.
— 19 —