Filter
Top Products
E7
GETTING
STARTED
C. Connect the base unit and charge the handset
1 Connect the AC adapter to the
DC IN 9V jack and to a standard
120V AC wall outlet.
2 Set the base on a desk or tabletop.
3 Place the handset in the base unit
for 15-20 hours without interruption.
The base unit’s LED light (labeled
CHARGE) illuminates once the
handset is placed in the base. The
LED light will illuminate whether the
battery pack is connected or not.
If the base CHARGE LED light does not illuminate:
• Check to see if the AC adapter is plugged into the base unit and the
electrical wall outlet properly.
• Check to see if the handset is sitting correctly in the base and making
good contact with the base unit’s charging contacts.
• Connect the AC adapter to a continuous power supply.
• Place the base unit close to the AC outlet so that you can unplug the AC adapter easily.
• It is normal for the handset and base to get warm, when the handset is charging in the
base unit.
Notes:
• Use only the supplied SANYO AC adapter. Do not use any other AC adapter.
• Do not place the power cord so that it creates a trip hazard or where it could become
damaged and create a fire or electrical hazard.
IMPORTANT
UP800DH(CLT-D5880) OM 1/24/06 3:38 PM Page 7