Filter
Top Products
B. Install the rechargeable battery pack into the handset
The handset is powered by a rechargeable battery pack.
The battery recharges automatically when the handset is placed in the base
unit or charging cradle.
Charge the handset battery pack for at least 15-20 hours before using your
new cordless telephone for the first time! To maximize the charge capacity of
your battery pack, DO NOT plug the telephone cord into the base unit and
wall jack until the battery is fully charged.
1 Press down on the handset battery case cover
(use the finger indention for a better grip) and
slide the cover downward to remove.
2 Plug the battery pack connector (red & black
wires) into the jack inside the battery
compartment. (The connector notches fit into the
grooves of the jack only one way.) Match the
wire colors to the polarity label in the battery
compartment, connect the battery and listen for
a click to ensure connection.
3 Make sure you have a good connection by
pulling slightly on the battery wires. If the
connection is secure, the battery jack will remain
in place.
4 Place the battery case cover back on the handset
by sliding it upwards until it clicks into place.
E5
GETTING
STARTED
Use only the SANYO rechargeable battery pack supplied with your cordless telephone.
IMPORTANT
UP800DH(CLT-D5880) OM 1/24/06 3:37 PM Page 5