Sanyo CLT-D5880 Cordless Telephone User Manual


 
E52
ADDITIONAL
INFORMATION
If your phone is not performing to your expectations, please try these simple
steps first.
Troubleshooting
Suggestion
Make sure the AC adapter is plugged into the base or
the charger (if you have more than one handset) and
wall outlet.
Make sure the handset is properly seated in the cradle.
Make sure the charging contacts on the handset are
clean.
Move the handset and/or base away from metal objects
or appliances and try again.
Make sure that you are not too far from the base.
Check both ends of the base telephone line cord.
Make sure the AC adapter is plugged into the base and
wall outlet.
Disconnect the AC adapter for a few minutes, and then
reconnect it.
De-register the handset (see "De-register the Handset"
on page E23).
Change the digital security code (see "Changing the
Digital Security Code" on page E49).
Make sure that you are not too far from the base.
Make sure the line is not in use.
If an outside call is already established, you cannot
make another outside call.
Charge the batteries in the handset for 15-20 hours by
placing the handset on the base or charging cradle.
Make sure that you are not too far from the base.
De-register the handset (see "De-register the Handset"
on page E23).
Change the digital security code (see "Changing the
Digital Security Code" on page E49).
Make sure that another handset(s) is not in use, and try
the phone again.
Make sure that you are not too far from the base.
Symptom
The CHARGE LED
won't illuminate
when the
handset is
placed in the
cradle.
The audio
sounds weak.
Can't make or
receive calls.
The handset
doesn't ring or
receive a page.
Unavailable
appears in the
display.
UP800DH(CLT-D5880) OM 1/24/06 3:39 PM Page 52