Filter
Top Products
E22
USING
THE INTERFACE
Setting the Area Code
If you enter a 3-digit area code number in the "Area Code" option, your local
area code does not appear in the Caller ID message. For calls received from
outside your local area code, you will see a full 10-digit number.
1 Press the MENU soft key. Select the Global Setup
menu, and then the Area Code submenu.
2 Press the number keypad (0-9) to enter a 3-digit
area code.
3 Press the OK soft key. You will hear a confirmation tone.
Setting the Dial Mode
Sets the dial mode to tone or pulse. Most phone systems use tone dialing;
the default setting is tone dialing. Set the dialing mode to match the dialing
system used by your local phone service.
• If you are not sure of your dialing system, set the unit to tone dialing.
Make a trial call. If the call connects, leave the setting as is; otherwise set
the unit to pulse dialing.
• If your phone system requires pulse dialing and you need to send DTMF
tones in certain situations during a call, you can switch over to tone dialing
(refer to "Tone Dialing Switch-over" on page E29).
1 Press the MENU soft key. Select the Global Setup
menu, and then the Dial Mode submenu.
2 Press VOL/▲ or VOL/▼ to select
Tone
or
Pulse
(the initial setting is Tone).
3 Press the OK soft key. You will hear a confirmation tone.
Area Code
__
BACK
DELETE
OK
• If your calling area requires 10-digit dialing, do not program this option.
• If the area code has already been stored in memory, the stored area code will be
displayed. To change it, use the DELETE soft key and number keys to enter the new
area code.
Notes:
Dial Mode
Tone
Pulse
BACK
DELETE
OK
UP800DH(CLT-D5880) OM 1/24/06 3:38 PM Page 22