Filter
Top Products
The Integrated Answering Device
33
Setting the base ringer volume
You have three ringer options. One allows you to
turn the ringer off. The other two are volume levels.
You can change the ringer volume while in standby
mode or the incoming call is ringing. Ô
1. Press
RINGER.
You hear the ringer at the current volume level
([ ] High, [ ] Low, [ ] Off) (if you set the base
ringer volume to off, “Ringer off” is announced
in standby mode.) and it is displayed on the
base.
2. Press
RINGER repeatedly until the desired
ringer option appears.
3. The system displayed new ringer volume.
Temporarily Mute the Base Ringer and the Call
Screen
Press (
PLAY/STOP) to temporarily mute the
incoming ring. This also mutes the caller's message
being recorded (Call Screen). The ringer and the
Call Screen will be heard with the next incoming call.
The base ringer mute is canceled when pressing
RINGER.
The Call Screen mute is canceled when pressing
/VOL/SEL or /VOL/SEL.
Adjusting the speaker volume level
You can adjust the volume of the base speaker by
pressing the
/VOL/SEL or /VOL/SEL on the base.
Press
/VOL/SEL for louder or /VOL/SEL for
softer during the base speaker is being used except
for menu mode. The base speaker volume also
applies the Call Screen.
The numbers [ ]-[ ]are displayed on the base
indicating the volume levels. [ ] being the softest
and [ ] being the loudest.
Ô NOTE Ô
Although you have set the
base ringer to off, you will
still hear the ringer from the
handset on the base.
43-3857.book Page 33 Wednesday, February 18, 2004 12:40 PM